Representative photo — actual unit for this HP may vary slightly
Piston Compressors · Model MDP-3S
3 HP Single-Stage Piston Compressor
A step up for workshops running one or two air tools more regularly — impact wrenches, spray guns and pneumatic lifts — with a bigger receiver to reduce cycling.
Best for: Small fabrication units, Two-wheeler & car service, General workshop tools
| Motor power | 3 HP (2.2 KW) |
| Free air delivery (FAD) | 11 CFM |
| Max working pressure | 8 kg/cm² |
| Air tank capacity | 165 L |
| Phase / voltage | Single/3-phase, 230/415V |
| Dimensions (L×W×H) | 1100 × 500 × 950 mm |
| Approx. weight | 95 kg |
Call or WhatsApp
+91 93221 61376
Key features
- Larger 165 L tank reduces motor cycling under repeated tool use
- Available in single-phase or 3-phase depending on your supply
- Splash-lubricated pump for lower running noise
- Fitted pressure switch, safety valve & non-return valve
Other models in this range
Common questions
What is the difference between a piston (reciprocating) and a screw air compressor?
A piston compressor uses pistons moving inside cylinders to compress air in pulses — it is simpler, cheaper to buy and repair, and well suited to workshops or intermittent use of an hour or two a day. A screw compressor uses two meshing rotors to compress air continuously and smoothly — it costs more upfront but handles continuous, high-volume use with less vibration, lower noise and typically a longer service life. Factories running production lines or paint booths for a full shift usually need a screw compressor; a small garage or fabrication workshop is often better served by a piston unit.
What size or type of compressor do I need for my workshop or factory?
Sizing depends on your total air demand (CFM) at the pressure your tools or process need, plus how continuously the air is used. As a rough starting point: small workshops running one or two pneumatic tools intermittently are usually fine with a 1–5 HP piston compressor; CNC lines, paint booths, pneumatic assembly tools or continuous-process factories typically need a 10 HP-plus screw compressor with a properly sized receiver tank. We visit or ask a few questions about your equipment and usage pattern to recommend a size rather than guessing from HP alone — undersizing causes constant cycling and early wear, and oversizing wastes power.
Do you take my old compressor in exchange when I buy a new one?
This is evaluated case by case depending on the condition, brand and resale value of the old unit. Mention it when you enquire about a new compressor and we will inspect it and let you know if an exchange or buy-back is possible.
Ready to move on the 3 HP Single-Stage Piston Compressor?
Call or WhatsApp +91 93221 61376 with your requirement — we'll confirm availability, pricing and installation timeline.