Representative photo — actual unit for this HP may vary slightly
Piston Compressors · Model MDP-10D
10 HP Two-Stage Piston Compressor
The largest piston model in the range — for shops at the upper edge of what a reciprocating compressor suits before a screw compressor becomes the better running-cost choice.
Best for: Fabrication & CNC support, Light manufacturing lines, Multi-tool production
| Motor power | 10 HP (7.5 KW) |
| Free air delivery (FAD) | 35 CFM |
| Max working pressure | 10.5 kg/cm² |
| Air tank capacity | 500 L |
| Phase / voltage | 3-phase, 415V |
| Duty cycle | Continuous, 8–10 hrs/shift |
| Dimensions (L×W×H) | 1600 × 720 × 1300 mm |
| Approx. weight | 330 kg |
Call or WhatsApp
+91 93221 61376
Key features
- Highest-capacity piston unit in the range at 35 CFM
- Two-stage compression keeps running cost down at this size
- Suited to multiple simultaneous pneumatic tools
- A good comparison point before stepping up to a screw compressor — ask us which suits your duty cycle
Other models in this range
Common questions
What is the difference between a piston (reciprocating) and a screw air compressor?
A piston compressor uses pistons moving inside cylinders to compress air in pulses — it is simpler, cheaper to buy and repair, and well suited to workshops or intermittent use of an hour or two a day. A screw compressor uses two meshing rotors to compress air continuously and smoothly — it costs more upfront but handles continuous, high-volume use with less vibration, lower noise and typically a longer service life. Factories running production lines or paint booths for a full shift usually need a screw compressor; a small garage or fabrication workshop is often better served by a piston unit.
What size or type of compressor do I need for my workshop or factory?
Sizing depends on your total air demand (CFM) at the pressure your tools or process need, plus how continuously the air is used. As a rough starting point: small workshops running one or two pneumatic tools intermittently are usually fine with a 1–5 HP piston compressor; CNC lines, paint booths, pneumatic assembly tools or continuous-process factories typically need a 10 HP-plus screw compressor with a properly sized receiver tank. We visit or ask a few questions about your equipment and usage pattern to recommend a size rather than guessing from HP alone — undersizing causes constant cycling and early wear, and oversizing wastes power.
Do you take my old compressor in exchange when I buy a new one?
This is evaluated case by case depending on the condition, brand and resale value of the old unit. Mention it when you enquire about a new compressor and we will inspect it and let you know if an exchange or buy-back is possible.
Ready to move on the 10 HP Two-Stage Piston Compressor?
Call or WhatsApp +91 93221 61376 with your requirement — we'll confirm availability, pricing and installation timeline.